Car, OPEL, Vectra C, 2007, Y20DTH - PSG 16
Y20DTH - PSG 16 - 0
Identification
VIN no: W0L0ZCF6931079803
System identification: BOSCH0100
Software version number: FJCAS370
ECU software version number: 02 5A
Existing ECU type approval no: B02010
System: Y22DTR
Hardware key number: 0000000000
Identifier: 04 10
Part number: 5020109
Alpha code: SR
DTC
P0500 [7F]: Vehicle speed sensor 1/A/single range/performance
P1614 [50]: Wrong transponder key
P1616 [0]: Steering column module (CIM) - wrong environment identifier
Controls
Clear DTC
Data stream
Cooling fan relay 1: On
Cooling fan relay 2: On
Cooling fan relay 3: On
Brake pedal switch 2: On
Clutch pedal switch: On
Vehicle speed in cruise control range: Active
Cruise control tip switch: R (Resume)
Brake pedal switch 1: On
Cruise control: On
A/C relay: On
A/C information switch: On
A/C cut-off mode: Engine temperature
P/N switch: P-N
Warm up shift pattern: Active
Torque control: Active
Active driving program: Sport
Torque converter clutch solenoid: Active
Oil level: Normal
Engine oil level status: Warning
Engine oil change warning: Active
Ignition status: On
Engine running signal: Not active
Engine oil pressure: Low pressure
Normal engine operating temperature: Not active
Starter relay: Off
Glow time telltale: On
Glow time relay: Active
Diagnosis glow time relay: Not active
Accelerator pedal position at idle position: Yes
Idle speed offset: Vehicle is moving
Idle speed modified: No
Check engine telltale: Flash
Service vehicle soon telltale: Flash
Electronic throttle control (ETC) limp home mode: Engine stalled
Battery voltage: 23 V
Engine speed: 0 rpm
Target idle speed: 1025 rpm
Acceleration sensor: 5 m/s²
Vehicle speed sensor: 0 km/h
Engine coolant temperature sensor: 0.14 V
Engine coolant temperature sensor: 210 °C
Intake air temperature sensor: 1.00 V
Intake air temperature sensor: 215 °C
Outside air temperature: 149 °C
A/C pressure sensor: 5 V
A/C pressure sensor: 40 kPa
Mass air flow sensor: 0.02 V
Mass air flow sensor: 230 kg/h
Boost pressure sensor: 0.68 V
Boost pressure sensor: 18 kPa
Boost pressure command: 68 kPa
Target mass air flow: 24 kg/h
Accelerator pedal position sensor 1: 4.57 V
Accelerator pedal position sensor 2: 0.00 V
Calculated accelerator pedal position: 32 %
EGR valve command: 0 %
EGR feedback: 24.0 V
EGR valve: 100 %
Evaporative emission (EVAP) system, canister purge valve: 14 %
Fuel level sensor: 0.66 V
Fuel level sensor: 9 L
Pulse ratio throttle control solenoid valve: 92 %
Throttle position sensor: 0.00 V
Torque control request (AT): 24 N·m
Torque control request (TC): 64 N·m
Requested torque (ESP): 162 N·m
Swirl flap - control solenoid: 98 %
Boost pressure solenoid valve - duty cycle: 100 %
Barometric pressure sensor: 4 V
Barometric pressure sensor: 255 kPa
Actual injection quantity: 0 mg/strk
Start of delivery: 12 °
Engine oil temperature sensor: 0 V
Engine oil temperature sensor: -16 °C
Fuel temperature sensor: 4.98 V
Fuel temperature sensor: -5 °C
Injection pump speed: 113 rpm
Immobilizer
Delivery mode: Active
Immobilizer function programmed: No
Free start mode: Not active
Security wait time: Not active
Engine oil status
Engine oil life remaining: 127 %
Odometer
Odometer: 62 km
Odometer: 39 miles
Actuators test
Controls
Swirl flap - control solenoid
Boost pressure valve
Throttle valve actuator
EGR valve
Glow time relay
Check engine telltale
Glow time telltale
Utility
Controls
Reset oil life
Compression test
Edit tire circumference
Configuration
Controls
Edit configuration
Edit CAN configuration