Car, NISSAN, TIIDA (C11), 2008-, Europe, PVDOHC - Petrol

PVDOHC - Petrol - 0

Identification

VIN no: SJNFEAJ11U1849437

Manufacturer identification code reprogramming: A

Supplier number reprogramming: RA3

CRC value: 52 41

Part number: RA3CQ

Homologation code: RA3CQ

Number of reprogramming: 41

DTC

P0830: Clutch switch input - circuit malfunction

P0500: Vehicle speed sensor

Controls

Clear DTC

Data stream

Accelerator pedal position sensor: 0.0 %

Accelerator pedal position sensor: 0.0 %

Fuel temperature: -49 °C

EGR valve position sensor: 0.0 mV

Battery voltage: 12.99 V

Fuel rail pressure sensor: 0.8 MPa

Fuel rail pressure setting: 0.0 MPa

Mass air flow sensor: 10.0 mg/cp

Air flow demanded: 0.0 mg/cp

Intake manifold pressure: 1698.2 mbar

Boost pressure: 21.2 mbar

Inlet air temperature sensor: -50 °C

Exhaust gas temperature before turbocharger: 380.0 °C

Engine speed: 1000.0 rpm

Accelerated idle request: Active

Vehicle speed: 0.0 km/h

Immobilizer: Inactive

Severity LED 1: Inactive

Severity LED 2: Inactive

Starting: Active

Preheating relay control: Inactive

Preheating relay control: Inactive

EGR solenoid valve: Inactive

Fuel flow regulator: Inactive

Fuel pressure regulation: Inactive

Synchronisation: Not done

Engine coolant temperature sensor: 70 °C

Damper valve setpoint position: 0.0 %

Fan assembly: High

Barometric pressure sensor: 870.2 mbar

Fuel flow: 261.1 mg/cp

A/C power consumption: 1720.0 W

Motor: Crank

Clutch pedal operation: Inactive

Computer + after ignition: Not present

Injector 1 commanded ON: Inactive

Injector 2 commanded ON: Active

Injector 3 commanded ON: Active

Injector 4 commanded ON: Inactive

A/C pressure sensor: 0.00 V

Accelerator pedal position sensor 1: 0.0 %

Accelerator pedal position sensor 2: 0.0 %

Fuel pressure solenoid valve: 0.00 V

Fuel temperature sensor: 0.00 V

Mass air flow sensor supply voltage: 0.00 V

Boost pressure sensor: 0.00 V

Air temperature sensor: 0.00 V

INJCTR CONDNSR: 0.00 V

Diesel Particulate filter (DPF) differential pressure sensor: 0.00 V

Exhaust gas temperature before turbocharger: 0.00 V

Barometric pressure sensor: 0.00 V

Engine coolant temperature sensor: 0.00 V

Accelerator pedal position sensor 1: 0.00 V

Accelerator pedal position sensor 2: 0.00 V

Cruise control: Status 1

Fuel flow solenoid valve: 0.0 %

Linearised rail pressure: 0.0 MPa

Cylinder 1 flow corrections: 0.000

Cylinder 3 flow corrections: 0.000

Cylinder 4 flow corrections: 0.000

Cylinder 2 flow corrections: 0.000

EGR valve position recopy: 0.0 %

EGR valve opening reference: 0.0 %

EGR valve last offset: 0.0 mV

EGR valve first offset: 0.0 mV

OBD lamp: Off

Odometer warning lamp severity 1: 100.0 km

Odometer warning lamp severity 2: 100.0 km

Impact detected:

Water in fuel sensor: With

Accelerator pedal:

Code programmed: No

A/C pressure: 0.0 bar

Demand link comp: Inactive

Cooling fan low speed: Inactive

Cooling fan high speed: Inactive

Brake pedal switch 1: Inactive

Clutch pedal switch: Inactive

Cruise control/speed limiter buttons: Inactive

Cruise control/speed limiter: No detection

Brake pedal switch 2: Inactive

Cruise control/speed limiter deactivation: Not present

Cruise control setting: 0 km/h

CAN diagnostic support monitor

Bus off diagnostic: 0

Transmit diag: 0

VDC/TCS/ABS: 0

Instrument: 0

BCM/SEC: 0

TCM: 0

IPDM E/R: 0

Actuators test

Controls

A/C compressor relay

Fuel flow solenoid valve

Fuel pressure solenoid valve

High pressure fuel circuit leakage

Injectors

Prevention of electrical consumers

Static test of actuators

Turbocharger boost control solenoid valve

Air inlet flap

Preheating relay

Utility

Controls

Edit VIN

EGR adaptives

Programmed values

ECU learn reset

Pressure regulation adaptives

Configuration

Controls

Edit configuration