Car, NISSAN, FRONTIER , NAVARA (D40), 2020-, Mexico, EPS, DAST 3

Supplier number reprogramming: 6494334000

Part number: 237619576R

Supplier number: TRW

Calibration number: ABAAAAAAAAAAAAAAAAAH

Hardware number: 285000675R

Software number: S2RE01DB03

Edition number: S2RE01DB03

Diagnostic ID: A5

Hardware part number: A100

C1606: EPS motor

Clear DTC

Steering wheel angle status interpreted by the ESP: 0.0 °

Steering wheel angle velocity: 0.0 °/sec

Steering wheel angle sensor internal status 3: Not initialized

Steering wheel angle sensor internal status 2: No failure

Steering wheel angle sensor internal status 1: Not calibrated

Steering wheel angle offset: 0 °

Steering wheel angle: 0.0 °

Steering torque: -20.0 N·m

Target motor current: -127 A

Assist level: 0 %

Vehicle speed control: 0 kph

System mode:

EPS warning: No error

Electric motor speed: 0 °/sec

Ignition switch counter: 0

Target torque: -100 N·m

Rack end stop activation: Disabled

Actual motor current: -127 A

Motor temperature: 0 °C

ECU temperature: -50 °C

Battery voltage: 0.00 V

Ignition status: Off

Enhanced diagnostic activation: Disabled

Rack end stop status: Res not running

Derating assistance level: 0 %

EPS dongle:

Dongle pairing counter: 0

Dongle error: No error

Battery current: 0.0 A

Steering wheel angle velocity (internal): 0.0 °/sec

Dongle frames activation: Dongle frames not sent

Cranking stop ped mode activation: Disabled

Instrument warning lamp check activation: Disabled

Auto stop start status: Status 1

Anti-kickback activation: Disabled

Vehicle speed: 0.0 kph

Engine status: Status 1

CAN DTC filter: 0

Derating counter: 0

Rack end stop counter: 0

Anti-kickback counter: 0

Anti-kickback status: Not running

Idle stop control: 0

Auto stop start sub-sys mode: Status 1

Absolute steering angle sensor calibration activation: Disabled

Bus off diagnostic: 0

Transmit diag: 0

ECM: 0

VDC/TCS/ABS: 0

Instrument: 0

BCM/SEC: 0

Power steering: 0

EPS: 0

IPDM E/R: 0

Steering angle adjust