Car, MITSUBISHI, TRITON , L200 (KJ, L, K), 2019, KL2T, JJHFPRU, Auto Stop & Go (AS&G)
Speed control - Auto Stop & Go (AS&G) - 0
Identification
Identifier: 00 00
ECU origin: 04
Supplier number: 64
ECU ID: 00
Diagnostic version: 00
Hardware version number: 01 01
Software version: 01 12 01
Part number: 1640A001
Software number: 1640A00101
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
VIN no: --
Calibration ID: --
Calibration verification number (CVN): --
DTC
P0830: Clutch pedal position (CPP) switch "B" - circuit malfunction
Controls
Clear DTC
Data stream
Neutral switch: Off
Engine hood: Close
Clutch switch buttom: Off
Clutch switch upper: Off
Ignition switch: Off
Auto stop & go (AS&G) off switch: Off
Starter switch: Off
DC/DC OUT for powertrain (Input): Off
DC/DC OUT (Input): Off
Seat belt fasten status: Fastened
Starter lock circuit status: Lock
Electric oil pump active status: On
Brake lamp switch: SNA
Parking brake switch: On
Brake hold signal (H/W): On
Clutch status: SNA
Driver side door switch: Close
Engine status: Stall
Brake hold signal (CAN): Off
Idle stop enable (ASC ECU): Enable
Idle stop enable (T/M ECU): Enable
Idle stop enable (ENG ECU): Enable
Idle stop enable (A/C ECU): Enable
Engine ECU auto stop & go system failure: Off
Idle Stop enable (T/F ECU): Enable
Electric oil pump system failure: Off
ACC vehicle hold status: Off
ASC ECU AS & G system failure: Off
Idle stop enable (ACC): Enable
T/M ECU AS & G system failure: Off
Parking brake status: Release
Auto hold status: Off
Brake vacuum sensor: 11.9 kPa
Air temperature: 1.5 °C
Barometric pressure sensor: 99.4 kPa
Vehicle speed: 0 km/h
Accelerator pedal position: 0.0 %
Idle stop enable (Vehicle speed): Disable
DC/DC in (Output): Off
Starter relay for AS&G (Output): Off
DC/DC in for powertrain (Output): Off
Starter relay (Output): Off
Starter counter: 16776960 times
Brake hold request mode flag: Off
AS & G indicator (Output): Turn on
AS & G off indicator (Output): Turn off
Idle stop flag: Off
Idle stop disable timer: 21 sec
Acceleration sensor signal(+ decel,- accel): -10.24 m/s²
Brake booster pressure sensor signal (CAN): 53.8 kPa
Utility
Controls
Starter counter writing
Starter counter initialization