Car, MITSUBISHI, TRITON , L200 (KJ, L, K), 2017, KV1T, JJHFPL6, Lane Keep
Speed control - Lane Keep - 0
Identification
Identifier: 00 00
ECU origin: 04
Supplier number: 85
ECU ID: 00
Diagnostic version: 00
Hardware version number: 86 00
Software version: 86 00 04
Part number: 8638A037
Software number: 8637A69600
VIN no (original): --
Class: --
Model: --
Type: --
Model year: --
VIN no: --
Calibration ID: --
Calibration verification number (CVN): --
DTC
U0141: Lost communication with ETACS control module
Controls
Clear DTC
Data stream
Power supply: 25.5 V
Light sensor setting: Europe
Rain sensor function: Disable
Light sensor function: Disable
Ambient temperature: 615.35 °C
Vehicle speed: 137.5 km/h
Yaw rate sensor: -2.56 °/sec
Steering wheel angle sensor: Not initialized & fail
Steering wheel angle sensor: 6137.0 °
Brake switch: On
Left turn signal lamp: On
Ignition status: On
Right turn signal lamp: On
Engine cranking status: Cranking
LDW switch: On
Rain sensor: Off
Light sensor sensitivity: Level 5: Darker
Wiper auto stop: Off
Rain sensor sensitivity: Level 1 (Lowest)
LDW Status request: -
LDW Indicator request: Off
LDW Mode request: No request
Wiping stage: Off
Rain sensor information: Completed
Tail lamp: Off
Low beam: Off
Light sensor information: In progress / Fail
Tunnel detected: Detected
Lane Approach Distance (R): 0.15 m
Lane Approach Distance (L): 1.25 m
Lane width: 5.10 m
Lane detection (R): Off
Lane detection (L): On
Warning availability (R): On
Warning availability (L): On
Calib. stat.: Camera internal data: Not defined
Calib. status: Image adjustment: Not defined
Calib.integ.: Camera inter. data: 255 Count
Calib. integ.: Image adjustment: 250 Count
Rain sensor measurement value: 4090 Level
Actuators test
Controls
Vehicle speed offset mode
Warning request output
Standby request output
Temperature fail request output
System fail request output
Utility
Controls
Decalibration: All parameter
Decalibration: Image adjustment
Decalibration: Camera internal data
Calibration: Camera internal data
Calibration: Image adjustment
Stop: Image adjustment