Car, MITSUBISHI, ECLIPSE CROSS (GK), 2020, GK1W, XJSXL6, 4B40 (1.5, D4, MPI, DI, I, C, T, C, Auto Stop & Go(AS&G)) - MPI, GDI, DIESEL Automatic Selection 110
4B40 (1.5, D4, MPI/DI, I/C, T/C, Auto Stop & Go(AS&G)) - MPI/GDI/DIESEL Automatic Selection 110 - 0
Identification
Identifier: 00 01
ECU origin: 04
Supplier number: 85
ECU ID: 00
Diagnostic version: 01
Hardware version number: 00 00
Software version: 57 01 05
Part number: 1860B481
Software number: 1860B48100
VIN no (original): JMBXTGK1WJZ020900
Class: TG
Model: Pajero / Montero V8/V9
Type: V98W
Model year: 2007
VIN no: JMBLYV98W7J007862
Calibration ID: 1860B4810001
Calibration verification number (CVN): FF FF FF FF
DTC
Controls
Clear DTC
Data stream
Fuel system status A:OL: Yes
Fuel system status A:CL-Fault: Yes
Fuel system status A:CL: Yes
Fuel system status A:OL B2: Yes
Fuel system status A:OL-Drive: Yes
Fuel system status A:OL-Drive B2: Yes
Fuel system status A:OL-Fault: Yes
Fuel system status A:OL-Fault B2: Yes
Fuel system status B:OL: Yes
Fuel system status B:CL-Fault: Yes
Fuel system status B:CL: Yes
Fuel system status B:OL B2: Yes
Fuel system status B:OL-Drive: Yes
Fuel system status B:OL-Drive B2: Yes
Fuel system status B:OL-Fault: Yes
Fuel system status B:OL-Fault B2: Yes
MAP sensor: 39 kPa
Mass air flow sensor: 24.57 g/sec
Throttle position sensor (main): 13.3 %
O2 sensor 1, bank 1: 0.675 V
O2 sensor 2, bank 1: 0.680 V
O2 sensor 2, bank 3: 1.275 V
O2 sensor 1, bank 2: 1.275 V
O2 sensor 2, bank 2: 1.275 V
Equivalence ratio (lambda) sensor 1, bank 1: 1.993
A/F sensor 1, bank 1: 4.005 V
Equivalence ratio (lambda) sensor 1, bank 2: 0.074
A/F sensor 1, bank 2: 0.013 V
EGR valve, target position: 94.1 %
Fuel level input: 46.3 %
Barometric pressure sensor: 19 kPa
Throttle valve relative position: 14.9 %
Throttle position sensor (sub): 3.9 %
Accelerator pedal position sensor (main): 23.9 %
Accelerator pedal position sensor (sub): 17.3 %
Type of fuel: Bi-fuel propane
Ethanol: 52.9 %
Fuel rail pressure sensor (Absolute): 652910 kPa
Relative accelerator pedal position sensor: 67.4 %
Intake air temperature sensor 2: 35 °C
Boost pressure sensor 1: 0.91 kPa
Boost pressure sensor 2: 1.53 kPa
Waste gate position sensor: 16.1 %
Power supply voltage: 14.0 V
Vehicle speed: 12 km/h
Engine speed: 1103 rpm
Target idle speed: 1070 rpm
Intake air temperature sensor bank 1: 210 °C
Engine coolant temperature sensor: 215 °C
Mass air flow sensor: 117 mV
Engine load: 0 %
Throttle position sensor (main): 859 mV
Throttle position sensor (sub): 4121 mV
Throttle position sensor (main) learned value: 977 mV
Accelerator pedal position sensor (main): 918 mV
Accelerator pedal position sensor (sub): 3418 mV
Ignition advance angle: 61 °
Injection time: 0.0 ms
A/C pressure sensor: 0 mV
Electric power steering: 0.0 A
Short term fuel trim bank 1: 49.5 %
Long term fuel trim bank 1: 49.5 %
Knock retard angle: 59.8 °
Learned knock retard: 95.7 %
Intake camshaft phase position bank 1: 75.6 °
Exhaust camshaft phase position bank 1: 63.8 °
Cooling fan: 52.9 %
Waste gate duty (Solenoid type): 94.1 %
Waste gate duty (Motor type): 50.6 %
Evaporative emission (EVAP) system, canister purge valve: 2.0 %
High pressure fuel pump spill valve: 0 ms
Fuel level gauge: 80.8 %
Fuel tank temperature sensor: -26 °C
Fuel tank pressure difference: 10000 mV
Target ETV value: 0.123 V
Throttle valve actuator: 51.8 %
Cancel code: 135
A/C pressure sensor: 3.50 MPa
Learned ISC position (A/C off): -127.402 L/s
Learned ISC position (A/C on): -127.977 L/s
Calculated load value: 5.1 %
Absolute load value: 59.6 %
Battery temperature: 215 °C
Neutral switch: Off
Cranking signal: Off
A/C switch: Off
Idle speed: Off
Ignition switch: Off
Oil pressure switch: Off
Cruise control "On"/"Off" switch: Off
Cruise control: Off
Cruise control "Set" switch: Off
Clutch switch: Off
Cruise control "Resume" switch: Off
Neutral position switch (Cruise control): Off
Cancel switch: Off
Speed limiter main switch: Off
Stop light switch: Off
Charging battery mode flag: Off
Brake pedal switch normally closed: Off
Check battery: Off
Remote start check number: Normal
Blower fan signal: Off
A/C compressor relay: Off
Cooling fan high speed relay: On
Fuel pump relay: On
Power supply relay: On
ETV relay: On
Starter relay: On
Cooling fan low speed relay: On
Brake booster pressure sensor: 160.0 V
Vehicle consumption current: -7996.1 A
Longitudinal acceleration sensor: -6.1 m/s²
Ambient temperature: 47.5 °C
Battery deteriorated odometer (last): 140 km
Battery deteriorated odometer (2nd last): 32 km
Battery deteriorated odometer (3rd last): 32 km
AS&G disable timer: 10 sec
Starter counter: 524280 times
Electric oil pump active status: Off
Parking brake switch: On
Neutral gear position switch (AS&G): On
Engine hood switch: Close
Clutch switch bottom: Push
Driver door switch: Open
Clutch switch upper: Push
Auto stop & go (AS&G) off switch: On
Brake hold signal (CAN): On
DC/DC OUT for powertrain (Input): Off
Seat belt fasten status: -
DC/DC OUT (Input): -
Clutch status:
Auto stop & go (AS&G): On
Starter relay for AS&G (Output): On
AS & G indicator (Output): Turn on
AS & G off indicator (Output): Turn on
Starter relay (Output): On
DC/DC in for powertrain (Output): On
Brake hold request mode flag: On
DC/DC in (Output): Off
AS&G system failure (T/M ECU): On
AS&G operation (ASC ECU): Disable
Electric oil pump system failure: On
AS&G operation (T/M ECU): Disable
AS&G system failure (ASC. ECU): On
AS&G operation (A/C ECU): Disable
AS&G operation (Vehicle speed): Enable
Learned ISC position (A/C off): -12926.4 kPa
Learned ISC position (A/C on): -12926.4 kPa
Gasoline particulate filter (GPF) soot load level: Low
DC-DC error mode ODO: 1020 km
Exhaust temperature sensor 1 value (Upstream of the GPF1): 173 °C
Exhaust temperature sensor 2 value (Downstream of the GPF1): 56 °C
Gasoline particulate filter (GPF) differential pressure: 0.000 kPa
Gasoline particulate filter (GPF) soot load: 69.293 g/l
Readiness test
Catalyst monitoring: Not completed
O2 sensor monitoring: Not completed
Evaporate system monitoring: Not completed
O2 sensor heater monitoring: Completed
Actuators test
Controls
Injectors
Fuel pump
Evaporative emission (EVAP) system, canister purge valve
Ignition angle 5°BTDC
Cooling fan relay
Evaporative emission (EVAP) system, canister vent valve
A/C compressor relay
Oil control valve (CVVT)
Cooling fan high speed
Cooling fan low speed
Fuel pump
Utility
Controls
Edit VIN
Reset learned values
Starter counter writing
Starter counter initialization
Gasoline particulate filter (GPF) soot load
Gasoline particulate filter (GPF) regeneration
Timing chain maintenance
Controls
Reset learned values
Test/Limit value readout
Learned value read & save
Configuration
Controls
Edit configuration
Edit option configuration