Car, MITSUBISHI, LANCER SP (CX0), 2010, CX4A, LMUFZR6, AYC, ACD ACD+A.S.C.
Immobilizer - AYC/ACD ACD+A.S.C. - 0
Identification
Identifier: 00 02
ECU origin: 04
Supplier number: 85
ECU ID: 00
Diagnostic version: 02
Hardware version number: 00 00
Software version: F1 07 6A
Part number: 631A040
Software number: 8631A040-B
VIN no (original): JMBSNCZ4ACU000261
Class: NC
Model: Not defined
Type: Not allowed
Model year: 2012
VIN no: JMBSNCZ4ACU000261
Calibration ID: --
Calibration verification number (CVN): --
DTC
C2205: SAS internal error
Controls
Clear DTC
Data stream
AWC control mode: Default
Transmission gear position hold request: Off
System fail: Normal
ACD target torque (for meter): No transmit
Steering wheel angle sensor: 0.5 °
Steering angle speed: 0.0 °/sec
Steering wheel angle sensor: Normal
Accelerator pedal position sensor: 0.0 %
Engine speed: 0 rpm
Engine torque (Driver request): -500.0 N·m
Gear position: N
Left front wheel speed sensor: 0.0 km/h
Right front wheel speed sensor: 0.0 km/h
Left rear wheel speed sensor: 0.0 km/h
Right rear wheel speed sensor: 0.0 km/h
Left front wheel speed (raw value): 0.0 rpm
Right front wheel speed (raw value): 0.0 rpm
Left rear wheel speed (raw value): 0.0 rpm
Right rear wheel speed (raw value): 0.0 rpm
Yaw rate sensor: -0.940 °/sec
Lateral acceleration sensor: -2.640 m/s²
Longitudinal acceleration sensor: 0.160 m/s²
Brake switch (CAN input): Off
Parking brake switch (CAN input): Off
Backup lamp switch: Off
Ignition switch (input): Lock
Battery voltage (CAN input): 0.0 V
IOD fuse (input): On
Odometer (input): 0.0 km
Coding status: Not completed
T/M type (input): Undefined
Rear diff type (input): Undefined
ETACS coding status: Not completed
ECU connection (ABS): Not connected
ECU connection (ENGINE): Not connected
ECU connection (T/M): Not connected
ECU connection (SAS): Not connected
ABS fail flag: Off
ABS actuation flag: Off
ASC actuation flag: Off
ASC fail flag: Off
ASC switch mode: ASC on
Pressure sensor: 0.000 MPa
IG1: Off
Power supply: 0.00 V
Output load voltage: 0.00 V
Pressure sensor power: 0.00 V
Pressure sensor output: 0.00 V
Mode switch: Off
ACD proportion valve (indicated): 0.0 mA
Motor relay drive indication: Off
Yaw rate sensor (adjusted value): 2.60 °/sec
Steering wheel angle sensor (adjusted value): 4.5 °
Lateral acceleration sensor (adjusted value): -0.50 m/s²
Longitudinal G sensor (adjusted value): 0.00 m/s²
Chassis number writing counter: 0 times
Chassis number (original) lock: Unlock
Mileage counter: 0.0 km
Coding counter: 0 times
Utility
Controls
SAS calibration
ACD air bleeding
Oil level check
MOTOR DRIVE
ACD operation check
Control OFF