Car, MITSUBISHI, OUTLANDER (CW0), 2009, CW7W, XMXFZR6, AT, CVT, A-MT, TC-SST

Transaxle - AT/CVT/A-MT/TC-SST - 0

Identification

Identifier: 00 01

ECU origin: 04

Supplier number: 95

ECU ID: 00

Diagnostic version: 01

Hardware version number: 00 00

Software version: 2B 01 01

Part number: 8631A827

Software number: 8631A8270B

VIN no (original): JMBLMCX4A9U000341

Class: MC

Model: Pajero / Montero V8/V9

Type: V98W

Model year: 2007

VIN no: JMBLYV98W7J007862

Calibration ID: --

Calibration verification number (CVN): --

DTC

P0725: Engine speed signal CAN-bus malfunction

P1792: Loss of torque management signal A

Controls

Clear DTC

Data stream

Engine torque control source: T/M reduction

Brake switch: Off

Parking brake: On

Accelerator pedal position sensor: 0.0 %

Vehicle speed: 254.1 km/h

ABS/ASC operation flag: On

ABS/ASC status: ASC error

Lever position: 1st

Paddle shift switch up (+): Off

Paddle shift switch down (-): Off

Drive mode (Switch input): +

ASC gear hold request: Request (TCL)

AYC gear hold request: On

Left rear wheel speed sensor: 136.5 rpm

Right rear wheel speed sensor: 544.0 rpm

Left front wheel speed sensor: 18.5 rpm

Right front wheel speed sensor: 549.0 rpm

Cold shift request: On

Idle up request: Off

Torque limit by spark retard: Off

Torque increase request flag: On

Torque reduction request flag: Off

Torque limit by throttle closing: On

M/T temperature sensor: 78 °C

M/T temperature warning: On

Drive mode switch: SNA

Gear change mode: Undefined

Current gear: 2nd

Gear display: B Blinking

Target gear: SNA

T/M fail flag: Off

ECU status: Extended session

Current gear (internal data): N

Pre select gear (internal data): R

Gear odd (internal data): 3rd

Gear even (internal data): N

Clutch (odd) temperature: 8191.75 °C

Clutch (even) temperature: 353.75 °C

Clutch (odd) slip speed: -0.5 rpm

Clutch (even) slip speed: -0.5 rpm

Battery voltage: 43.00 V

Clutch (odd) pressure sensor: 256 mbar

Clutch (even) pressure sensor: 7072 mbar

Shift fork position sensor 1: 0.99 mm

Shift fork position sensor 2: 0.31 mm

Shift fork position sensor 3: 8.00 mm

Shift fork position sensor 4: -128.00 mm

Clutch shift pressure solenoid 1: 240 mA

Clutch shift pressure solenoid 2: -2048 mA

Clutch cooling solenoid: -0 mA

Line pressure solenoid: -2048 mA

Input shaft (odd) speed: -1.0 rpm

Input shaft (even) speed: -0.5 rpm

Damper speed sensor: -16384.0 rpm

ECU temperature (internal data): 64.50 °C

Coding counter: 119

Utility

Controls

Plausibility check

Shift fork learn

Line pressure test

Stroke Teach-In

Boost Teach-in

Interlock Teach-In

Clutch ventilation learn

Edit VIN

Configuration

Controls

Edit configuration