Car, MERCEDES, SMART 454, 454.001, OM639 - EDG (CDI)

OM639 - EDG (CDI) - 0

Identification

Production date: 00 00 00

Hardware number: 00.00

Software number: 00.00

Diagnostic version: 198.12

MB number for hardware: 00 00 00 00 00

Supplier: Not defined

Identifier: C6 0C

VIN no: WDB2112261A379574

DTC

2773: No or incorrect CAN message from ESP control module

Controls

Clear DTC

Data stream

VIN no (original):

VIN no: WDB2112261A379574

Engine speed: -14249 rpm

Inlet port shutoff: 171.85 %

Accelerator pedal position sensor 1: 270.21 %

Accelerator pedal position sensor 2: -376.89 %

Idle speed: 17185 rpm

Injection time bank 1: 4660 us

Vehicle speed sensor: 291.25 km/h

Winter tire maximum speed: -46.61 km/h

Fuel quantity control valve: -172 %

Left front wheel speed (CAN): 2330 rpm

Right front wheel speed (CAN): 11068 rpm

Left rear wheel speed (CAN): 8592 rpm

Right rear wheel speed (CAN): -15438 rpm

Odometer: 582 km

Odometer display: 152577846 km

Mass air flow sensor: 466.00 kg/h

Mass air flow sensor: 56.40 kg/h

Intake air temperature sensor: 193 °C

Ambient temperature sensor: 1445 °C

Barometric pressure sensor: 4660 hPa

Boost pressure sensor: 17185.00 hPa

Battery voltage: -74.4 V

Fuel pump: On

Fuel rail pressure: 466 bar

Generator: On

Target fuel rail pressure: 1718 bar

Fuel temperature sensor: -135 °C

Fuel rail pressure control valve: 46600.00 mm³/s

Terminal 61: On

Fuel consumption: 172 L/h

Fuel temperature sensor: 193 °C

MAP sensor: -26.83 bar

Fuel rail pressure control valve: 172 %

Fuel tank level: 4660 L

Engine oil temperature sensor: -3102 °C

Oil pressure sensor: On

Engine torque: 29 N·m

Diesel Particulate filter (DPF) distance since last regeneration: 9320 km

Engine coolant temperature sensor: -244 °C

Soot content of particulate filter: -327.68 g

Ash content of particulate filter: -145.06 g

Control module temperature: 88 °C

Air mass (Specified value during particulate filter regeneration): 27 mg/hub

Lambda value: 6.18

Exhaust gas temperature: -2520 °C

O2 sensor 1 heater: -145 %

Heater booster enable: Yes

Starter relay: On

Terminal 15: On

Circuit 50: On

A/C compressor: 73 %

Delayed cooling fan switch off: On

Preglow indicator lamp: On

Generator output: 210 %

Accelerator pedal position sensor 1: 23 V

Accelerator pedal position sensor 2: 12 V

Fuel tank level minimum: Reached

Tire circumference: 1 m

O2 sensor 1 heater: 100 %

Inlet port shutoff: 78 %

Exhaust gas recirculation: 78 %

Quantity correction at idle

Injector cylinder 1: --

Injector cylinder 2: --

Injector cylinder 3: --

Cylinder 1 selective quantity correction: 133.98 mm³/hub

Cylinder 2 selective quantity correction: 177.67 mm³/hub

Cylinder 3 selective quantity correction: 221.36 mm³/hub

Fuel quantity: 46.60 mm³/hub

Injected fuel quantity: 46.60 mm³/hub

Status of injection valve shutoff, bank 1: Active

Cylinder 1 fuel injector: 17185 us

Cylinder 2 fuel injector: 22136 us

Cylinder 1 injector: -30875 us

Cylinder 2 injector: -25924 us

Smoke limitation: 171.85 mm³/hub

Actuators test

Controls

Fuel pump

Glow time relay

O2 sensor 1, bank 1 heater

A/C compressor relay

Inlet port shutoff motor

EGR valve

Injectors

Electronic throttle control (ETC)

Heater booster

Check engine telltale

Preglow indicator lamp

Utility

Controls

Injectors replacement

Diesel particulate filter replacement

Edit VIN

Configuration

Controls

Edit configuration