Car, MERCEDES, G 463, 463.233 G 320, M113 - ME2.0 (ME)
M113 - ME2.0 (ME) - 0
Identification
MB number for hardware: 11 31 53 20 79
Diagnostic version: 1.8
Hardware number: 01.00
Software number: 26.01
Supplier: Bosch
Diagnostic version: 28
VIN no: --
DTC
P1605 [89]: CAN acceleration info for poor road recognition from ABS speed sensor
P0155 [136]: O2 sensor 1, bank 2 heater
P0135 [8]: O2 sensor 1, bank 1 heater
P0410 [3]: Secondary air injection system - malfunction
P0161 [137]: O2 sensor 2, bank 2 heater
P0170 [22]: Fuel trim system, bank 1 at limit value (part load)
P0300 [80]: Misfire detected for catalyst damage
P0302 [85]: Misfire detected for catalyst damage, cylinder 2
P0153 [128]: O2 sensor 1, bank 2 aging, period too long
P0300 [67]: Misfire
Controls
Clear DTC
Data stream
Engine oil level status: Ok
Idle speed: On
Air conditioner: Off
Full load: Off
Selector lever position: P, N
Fuel tank level: 51 L
Battery voltage: 12.4 V
Coolant temperature at engine start: 47 °C
Engine coolant temperature sensor: 90 °C
Intake air temperature sensor: 52 °C
Engine speed: 0 rpm
Safety fuel cut-off: Off
Post-start enrichment: Off
CAT heating idle speed: Off
Throttle valve stop learned: Yes
Engine oil temperature sensor: 88 °C
Oil quality: 2
Mass air flow sensor: 0.00 kg/h
HFM voltage: 1.089 V
Injection time bank 1: 0 ms
Injection time bank 2: 0.00 ms
Ignition angle: 54 °
Throttle position sensor: 4 °
Evaporative emission (EVAP) system, canister purge valve: 0 %
Evaporative emission (EVAP) system, canister purge valve: Off
Knock sensor: Off
Transmission protection: Off
O2 sensor 1, bank 1 loop control: 0 %
O2 sensor 1, bank 1: 0.456 V
Self-adaptation in idle speed range, bank 1 of cylinders: -0.237 ms
O2 sensor 1, bank 2 loop control: 0 %
O2 sensor 1, bank 2: 0.466 V
Self-adaptation in idle speed range, bank 2 of cylinders: -0.498 ms
O2 sensor 2, bank 1: 0.466 V
O2 sensor 2, bank 2: 0.461 V
O2 sensor 2, bank 1 loop control: 1 ms
O2 sensor 2, bank 2 loop control: 1 ms
Vehicle speed at front axle: 0 km/h
Vehicle speed at rear axle: 0 km/h
Engine load: 0 %
Knock sensor 1: 0.00 V
Knock sensor 2: 0.00 V
Knock signal cylinder 1: 0 °
Knock signal cylinder 2: 0 °
Knock signal cylinder 3: 0 °
Knock signal cylinder 4: 0 °
Knock signal cylinder 5: 0 °
Knock signal cylinder 6: 0 °
Knock signal cylinder 7: 0 °
Knock signal cylinder 8: 0 °
Self-adaptation factor in partial load operation, cylinder bank 1: 0.985
Self-adaptation factor in partial load operation, cylinder bank 2: 1.044
Throttle position sensor 1: 4 V
Throttle position sensor 2: 1 V
Accelerator pedal position sensor 1: 0 V
Accelerator pedal position sensor 2: 0 V
Stop light switch: Off
Drive autorization RCL and engine control module identified: Yes
Engine control module interlocked: Yes
DAS and engine control module compatible: Yes
Start enable: Yes
Number of starts with non-interlocked engine control module: 0
Fan power effective on/off ratio: 0 %
A/C fan power request: 40 %
Engine fan power request: 0 %
Load correction factor: 2.05
Torque control: 0 N·m
Engine coolant temperature (ADC): 0.63 V
Intake air temperature sensor (ADC): 1.32 V
Intake manifold pressure (MAP) (ADC): 5.00 V
Exhaust gas temperature: 48 °C
Idle speed actuator: 4 °
Quantity correction values of smooth-running control
Engine speed: 0 rpm
Engine speed (specified): 803 rpm
Smooth running shut off threshold: 0.00 (1/s)²
Smooth running of cylinder 1: 0.00 (1/s)²
Smooth running of cylinder 5: 0.00 (1/s)²
Smooth running of cylinder 4: 0.00 (1/s)²
Smooth running of cylinder 2: 0.00 (1/s)²
Smooth running of cylinder 6: 0.00 (1/s)²
Smooth running of cylinder 3: 0.00 (1/s)²
Smooth running of cylinder 7: 0.00 (1/s)²
Smooth running of cylinder 8: 0.00 (1/s)²
Misfire cylinder 1: 4
Misfire cylinder 5: 0
Misfire cylinder 4: 0
Misfire cylinder 2: 0
Misfire cylinder 6: 0
Misfire cylinder 3: 0
Misfire cylinder 7: 0
Misfire cylinder 8: 0
Actuators test
Controls
Injectors
Canister purge valve
EGR vacuum transducer
Mixture adaptation
Engine/AC electric suction fan
Intake manifold level