Car, MERCEDES, G 463, 463.240 G 500, M113 - ME2.0 (ME)

M113 - ME2.0 (ME) - 0

Identification

MB number for hardware: 11 31 53 20 79

Diagnostic version: 1.8

Hardware number: 01.00

Software number: 26.01

Supplier: Bosch

Diagnostic version: 28

VIN no: --

DTC

P1605 [89]: CAN acceleration info for poor road recognition from ABS speed sensor

P0155 [136]: O2 sensor 1, bank 2 heater

P0135 [8]: O2 sensor 1, bank 1 heater

P0410 [3]: Secondary air injection system - malfunction

P0161 [137]: O2 sensor 2, bank 2 heater

P0170 [22]: Fuel trim system, bank 1 at limit value (part load)

P0300 [80]: Misfire detected for catalyst damage

P0302 [85]: Misfire detected for catalyst damage, cylinder 2

P0153 [128]: O2 sensor 1, bank 2 aging, period too long

P0300 [67]: Misfire

Controls

Clear DTC

Data stream

Engine oil level status: Ok

Idle speed: On

Air conditioner: Off

Full load: Off

Selector lever position: P, N

Fuel tank level: 51 L

Battery voltage: 12.4 V

Coolant temperature at engine start: 47 °C

Engine coolant temperature sensor: 90 °C

Intake air temperature sensor: 52 °C

Engine speed: 0 rpm

Safety fuel cut-off: Off

Post-start enrichment: Off

CAT heating idle speed: Off

Throttle valve stop learned: Yes

Engine oil temperature sensor: 88 °C

Oil quality: 2

Mass air flow sensor: 0.00 kg/h

HFM voltage: 1.089 V

Injection time bank 1: 0 ms

Injection time bank 2: 0.00 ms

Ignition angle: 54 °

Throttle position sensor: 4 °

Evaporative emission (EVAP) system, canister purge valve: 0 %

Evaporative emission (EVAP) system, canister purge valve: Off

Knock sensor: Off

Transmission protection: Off

O2 sensor 1, bank 1 loop control: 0 %

O2 sensor 1, bank 1: 0.456 V

Self-adaptation in idle speed range, bank 1 of cylinders: -0.237 ms

O2 sensor 1, bank 2 loop control: 0 %

O2 sensor 1, bank 2: 0.466 V

Self-adaptation in idle speed range, bank 2 of cylinders: -0.498 ms

O2 sensor 2, bank 1: 0.466 V

O2 sensor 2, bank 2: 0.461 V

O2 sensor 2, bank 1 loop control: 1 ms

O2 sensor 2, bank 2 loop control: 1 ms

Vehicle speed at front axle: 0 km/h

Vehicle speed at rear axle: 0 km/h

Engine load: 0 %

Knock sensor 1: 0.00 V

Knock sensor 2: 0.00 V

Knock signal cylinder 1: 0 °

Knock signal cylinder 2: 0 °

Knock signal cylinder 3: 0 °

Knock signal cylinder 4: 0 °

Knock signal cylinder 5: 0 °

Knock signal cylinder 6: 0 °

Knock signal cylinder 7: 0 °

Knock signal cylinder 8: 0 °

Self-adaptation factor in partial load operation, cylinder bank 1: 0.985

Self-adaptation factor in partial load operation, cylinder bank 2: 1.044

Throttle position sensor 1: 4 V

Throttle position sensor 2: 1 V

Accelerator pedal position sensor 1: 0 V

Accelerator pedal position sensor 2: 0 V

Stop light switch: Off

Drive autorization RCL and engine control module identified: Yes

Engine control module interlocked: Yes

DAS and engine control module compatible: Yes

Start enable: Yes

Number of starts with non-interlocked engine control module: 0

Fan power effective on/off ratio: 0 %

A/C fan power request: 40 %

Engine fan power request: 0 %

Load correction factor: 2.05

Torque control: 0 N·m

Engine coolant temperature (ADC): 0.63 V

Intake air temperature sensor (ADC): 1.32 V

Intake manifold pressure (MAP) (ADC): 5.00 V

Exhaust gas temperature: 48 °C

Idle speed actuator: 4 °

Quantity correction values of smooth-running control

Engine speed: 0 rpm

Engine speed (specified): 803 rpm

Smooth running shut off threshold: 0.00 (1/s)²

Smooth running of cylinder 1: 0.00 (1/s)²

Smooth running of cylinder 5: 0.00 (1/s)²

Smooth running of cylinder 4: 0.00 (1/s)²

Smooth running of cylinder 2: 0.00 (1/s)²

Smooth running of cylinder 6: 0.00 (1/s)²

Smooth running of cylinder 3: 0.00 (1/s)²

Smooth running of cylinder 7: 0.00 (1/s)²

Smooth running of cylinder 8: 0.00 (1/s)²

Misfire cylinder 1: 4

Misfire cylinder 5: 0

Misfire cylinder 4: 0

Misfire cylinder 2: 0

Misfire cylinder 6: 0

Misfire cylinder 3: 0

Misfire cylinder 7: 0

Misfire cylinder 8: 0

Actuators test

Controls

Injectors

Canister purge valve

EGR vacuum transducer

Mixture adaptation

Engine/AC electric suction fan

Intake manifold level