Car, MERCEDES, E 213, 213.011 Е 300 de 4MATIC Sedan, Front signal acquisition and actuation module (DSAM)

Body control module - Front signal acquisition and actuation module (DSAM) - 0

Identification

Diagnostic version: 00 04 1A

Boot software number: 0.0.0

Hardware version: 0.0.0

Software version: --

Software version 1: --

Software version 2: --

Supplier: --

Hardware part number:

Software part number (customer): --

Software part number (code): --

Software part number (data): --

Serial number: --

VIN no:

DTC

P010000: Mass or volume air flow (MAF) sensor 1/A - electrical fault

Controls

Clear DTC

Data stream

Circuit 30 (1): 0.0 V

Circuit 30 (2): 0.0 V

Circuit 15: 0.0 V

Outside air temperature sensor analog input: 0.00 mV

Brake fluid level switch: 0.00 V

Right front brake wear sensor: Not active

Coolant level switch: 0.00 V

Windshield washer fluid level indicator switch: 0.00 V

Supply voltage of dedicated short-range communications control unit: Off

Supply voltage of weight sensing system (WSS) control unit: Off

Fanfare high tone: Off

Fanfare low tone: Off

Duct 1 of exterior lights switch: Left parking light

Duct 2 of exterior lights switch: Fault

Duct 3 of exterior lights switch: ---

Hazard warning system button illumination: Off

Right high beam: Off

Left high beam: Off

Right rear turn signal lamp: Off

Left rear turn signal lamp: Off

Left rear side-marker lamp: Off

Right rear side-marker lamp: Off

Footwell light: Off

Outside temperature: -40.00 °C

Brake fluid pressure (calculated): 0.00 V

Brake fluid level indicator lamp: Off

Brake linings indicator lamp: Off

Coolant level indicator lamp: Off

Washer fluid level indicator lamp: Off

Left engine hood contact switch: --

Right engine hood contact switch: Undefined

Windshield wiper stage: --

Outside air temperature internally calculated: 0.00 V

Input signals: outside air temperature: Ok

Status of input signal 'Brake fluid level switch': Ok

Right front brake wear sensor: Ok

Right rear brake wear sensor: Ok

Coolant level switch (calculated): 0.00 V

Windshield washer fluid level indicator switch (calculated): 0.00 V

Washer fluid level indicator lamp (temperature is too low): Off

Terminal 58d input value: 0.00 V

Status of input signal 'Hazard warning system button': Not operated

Right front brake wear sensor: Off

No-load current shutoff relay: Off

Crash signal: Off

Right engine hood contact switch: Undefined

Windshield washer pump: Off

Spray nozzle hose heater: Off

Engine start request by ECO start/stop function: Not active

Engine stop inhibit - diagnosis: Not active

Engine stop inhibit - on-board electrical system: Not active

Engine stop inhibit - battery: Not active

Engine stop inhibit - ambient conditions: Not active

Engine stop inhibit - LIN error: Not active

Frequency counter 'Activation of component 'Fanfare horn'' (<1s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (1s-5s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (5s-10s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (>10s): --

Production mode: Not active

Transport mode: Not active

Test of no-load current: Not performed

Odometer: 0 km

Remaining service life: 0 days

Were you prompted to change the battery?: No

Charge level: 0.00 %

Electrical charge throughput: 0.00 Ah

Electrical charge throughput: -- Ah

Speed threshold: -- km/h

Parking position: Off

Crash signal: Off

Circuit 30g voltage: 0.00 V

Circuit 15 relay: Undefined

Fanfare high tone: 0.00 A

Fanfare low tone: 0.00 A

Supply voltage of weight sensing system (WSS) control unit: 0.00 A

Crash signal: Close

Brake fluid level switch: Closed

Coolant level switch: Closed

Windshield washer fluid level indicator switch: Closed

Diagnostic trace memory: 00 00 00 00 00 00 00 00 00 00 00 00

Actuators test

Controls

Exterior lighting

Windshield washer system pump

Headlamp cleaning system pump (rear window)

Reserve relay

Spray nozzle hose heater

Circuit 15 relay

Fanfare horns

External ligts demo mode

Windshield wiper

Footwell light

Confirmation of battery change

Deep dischange protection

Configuration

Controls

Variant coding WWC

Activate SAR data storage

Closure switch model

ILC HW approvals