Car, CHERY, EASTAR, MIKADO , ORIENTAL SON (B11FL, B11), 4G63 - Delphi II (ECM)

Supplier ECU hardware number: 0100026120835

Manufacturing number: 91037392168

Supplier ECU software number: Q00

System: 80EF

Software number: ñ2

P0130: O2 sensor 1, bank 1 - circuit malfunction

Clear DTC

Number of DTC: 2

MAP sensor: 104.4 kPa

MAP sensor: 4.973 V

Battery voltage: 25.50 V

Intake air temperature sensor: -40.0 °C

Engine coolant temperature sensor: -40.0 °C

Ignition angle: -90.0 °

Throttle position sensor: 0.020 V

Throttle position sensor: 12.4 %

Vehicle speed sensor: 0 km/h

Engine speed: 272 rpm

Injection time bank 1: 0.0 ms

Idle speed actuator: 0 steps

Target idle speed: 0.0 rpm

O2 sensor 1, bank 1: 0.765 V

Evaporative emission (EVAP) system, canister purge valve: 0.0 %

Air/Fuel ratio: 0.0 :1

Power enrichment: Yes

O2 sensor loop control bank 1: Closed Loop

DFCO mode: Disable

O2 sensor 1, bank 1: Lean

Block learn: Not active

Clear flood mode: Active

Torque control signal: Not active

Closed loop stepper opening: Enable

Target idle speed actuator: Not active

Fuel pump relay: Off

A/C request: Not active

A/C pressure sensor: Low

A/C relay: On

Ignition switch: Closed

Check engine telltale: Closed

O2 sensor 1, bank 1 heater: Closed

Injector cylinder 3: Low battery

Injector cylinder 1: Low battery

Injector cylinder 4: Voltage high

Injector cylinder 2: Ok

Barometric pressure sensor: 57.6 kPa

Time since engine start: 0 sec

Anti theft learn: No

Anti theft incorrect: No

Immobilizer status: Not active

Anti theft replay incorrect: No

Anti theft no response: No

Wrong transponder key: No

Check engine telltale

Evaporative emission (EVAP) system, canister purge valve

Fuel pump relay

Ignition coil

A/C relay

Cooling fan relay 1

Cooling fan relay 2

Ignition angle

Idle rpm control

Air/Fuel ratio

Idle speed actuator

Evaporative emission (EVAP) system, canister purge valve

Injectors