Car, CHERY, QQ3, SWEET (S11), SQR 372 - MT Marelli (ECM)
SQR 372 - MT Marelli (ECM) - 0
Identification
Hardware number: 13456789ABC
Hardware version number: 31
Software number: 13456789ABC
Software version: 31 33
DTC
P1687: Signal difference between electroic throttle position sensor L1 and L2
P0302: Misfire detected, cylinder 2
P0136: O2 sensor 2, bank 1 - circuit malfunction
Controls
Clear DTC
Data stream
Engine speed: 65535 rpm
MAP sensor: 4883 mbar
Air temperature sensor: 21805 °C
Water temperature: 215 °C
Throttle position sensor Angle1-Voltage(5V base): 950.9
Ignition angle: 25.5 °
Average ignition angle: 30.9 °
Engine load: 2730.6 kg/h
Injection time bank 1: 131.1 ms
Target idle speed: 13364 rpm
Idle speed actuator: 13364 steps
Battery voltage: 539.70 V
Ignition angle cylinder 1: -3058.4 °
Ignition angle cylinder 2: -3058.4 °
Ignition angle cylinder 3: -3058.4 °
Knock signal cylinder 1: 46403.9 mV
Knock signal cylinder 2: 46403.9 mV
Knock signal cylinder 3: 22574.9 mV
O2 sensor 1, bank 1: 4626 mV
Air/Fuel ratio sensor 1, bank 1: 0.5 %
O2 sensor 1, bank 1 loop control:
Lambda 1 sensor OBD1 diagnosis status: Not defined
Fuel system distribution EOBD diagnosis status: Not defined
Evaporative emission (EVAP) system, canister purge valve: 462.6 %
Vehicle speed sensor: 950.9 km/h
Ignition coil 1 dwell time: 19.0 ms
Ignition coil 2 dwell time: 69.9 ms
Power latch time: 34952 ms
Power latch start: Not active
Power latch end: No
Engine status: Not defined
Engine mode:
Stabilized in crank: Not active
Deceleration in crank: Not active
Acceleration in crank: No
Vehicle status: Running
A/C output status: Not defined
A/C input status: On
Throttle position sensor: Not defined
Barometric pressure sensor: 34644 mbar
Throttle position sensor: 520.8 %
Water temperature: On
Battery voltage: Increase
Cooling fan:
Ignition coil 3 dwell time: 10.480 ms
Actuators test
Controls
A/C relay
Cooling fan relay 1
Cooling fan relay 2
Fuel pump relay
Evaporative emission (EVAP) system, canister purge valve