Car, KIA, General, SOUL (PS), 2016, D 1.6 TCI-U2, Electronic stability control system (ESC)
Brake system - Electronic stability control system (ESC) - 0
Identification
Vehicle name:
System name:
Hardware version number:
Software version number:
Supplier specific ECU number :: FF FF FF
HMC/KMC part configuration:
DTC
Controls
Clear DTC
Data stream
Engine speed: 0.0 rpm
Vehicle speed: 0 km/h
Throttle position sensor: 4.7 %
Shift lever position: P, N
Battery voltage: 11.48 V
Left front wheel speed sensor: 0 km/h
Right front wheel speed sensor: 0 km/h
Left rear wheel speed sensor: 0 km/h
Right rear wheel speed sensor: 0 km/h
TCS/ESP warning telltale: Off
ABS telltale: Off
TCS/ESP off lamp: Off
EBD telltale: Off
Brake pedal switch normally closed: Not supported
ESP switch: Off
Brake light switch: Off
DBC/HAC brake lamp relay: Not supported
Motor relay: Off
ESS brake lamp relay: Not supported
Valve relay: On
Motor: Off
Left rear inlet solenoid valve: Off
Left front inlet solenoid valve: Off
Right rear inlet solenoid valve: Off
Right front inlet solenoid valve: Off
Left rear outlet solenoid valve: Off
Left front outlet solenoid valve: Off
Right rear outlet solenoid valve: Off
Right front outlet solenoid valve: Off
TCS valve (HSV1): Off
TCS Valve (USV1): Off
TCS valve (HSV2): Off
TCS Valve (USV2): Off
Steering wheel angle sensor (CAN): -10.3 °
Steering wheel angle sensor: Ok
Steering wheel angle sensor calibrated: Calibrated
Lateral acceleration sensor: 0.020 g
Yaw rate sensor: -0.2 °/sec
Pressure sensor-Pressure: 1.3 bar
Parking brake signal: Activated
Longitudinal acceleration sensor: -0.0 g
Actuators test
Controls
Motor
Left front inlet solenoid valve
Right front inlet solenoid valve
Left rear inlet solenoid valve
Right rear inlet solenoid valve
Left front outlet solenoid valve
Right front outlet solenoid valve
Left rear outlet solenoid valve
Right rear outlet solenoid valve
Left front TC valve
Right front TC valve
Right front ESV (ESP) valve
Left front ESV (ESP) valve
DBC brake lamp relay
ESS brake lamp relay
Utility
Controls
HCU air bleeding
Auto detected configuration reset (ESP(ESC) only)
Hill start assist control setting
Longitudinal G Sensor Calibration(HAC/DBC Only)