Car, KIA, General, CERATO (LD), 2007, G 2.0 DOHC, G 2.0 DOHC - Unleaded EOBD (ENGINE)
G 2.0 DOHC - Unleaded EOBD (ENGINE) - 0
Identification
Software version bootloader:
ECU software version number: --
Calibration ID:
DTC
Controls
Clear DTC
Data stream
A/C switch: On
Vehicle transmission type: A/T
A/C status: On
Cooling fan high speed: On
A/C compressor: On
Ignition voltage: On
Cooling fan low speed: On
Fuel pump: On
Throttle closed position: On
Main relay: On
Throttle full open: On
Camshaft and crankshaft synchronization: On
Fuel cut-off: On
Starting status: On
O2 sensor 1, bank 1 correction: On
O2 sensor 2, bank 1 correction: On
Knocking detection: On
Canister purge state: On
MAP sensor: 319.81 V
MAP sensor: 2560.0 hPa
Throttle position sensor: 4.98 V
Throttle position PWM servo signal: 100.0 %
Adapted throttle position sensor: 98.3 %
Engine speed: 10200 rpm
Battery voltage: 17.37 V
Engine coolant temperature sensor: 143.2 °C
Engine coolant temperature sensor (model): -- °C
Intake air temperature sensor: -- °C
Evaporative emission (EVAP) system, canister purge valve: -- %
Relative fuel injection quantity of canister control: -- %
Injection time cylinder 1: -- ms
Injection time cylinder 2: -- ms
Injection time cylinder 3: -- ms
Injection time cylinder 4: -- ms
Actual torque: 100.0 %
O2 sensor 1, bank 1 heating time: 2550 ms
O2 sensor 2, bank 1 heating time: 2550 ms
Target idle speed: 2550 rpm
Idle speed actuator: 100.0 %
Engine speed: 16383.8 rpm
Engine oil temperature: -- °C
Calculated oil temperature: -- °C
Ignition angle cylinder 1: -- °
Ignition angle cylinder 2: -- °
Ignition angle cylinder 3: -- °
Ignition angle cylinder 4: -- °
Vehicle speed: -- km/h
Long term fuel trim (idle) bank 1: -0.0 %
Long term fuel trim (part load) bank 1: -0.0 %
O2 sensor 1, bank 1: 319.67 V
O2 sensor 2, bank 1: -- V
Short term fuel trim bank 1: -- %
A/F correction: Close
Ignition dwell time: 262.1 ms
Camshaft position: 155.6 °
Target camshaft position: 155.6 °
CVVT status: -
CVVT actuation status: Adjust
CVVT valve duty: 100.0 %
CVVT duty control status: -
Actuators test
Controls
Check engine telltale
Fuel pump relay
A/C compressor relay
Fuel pump control
Immobilizer telltale
Cooling fan high speed
Cooling fan low speed
Main relay
Evaporative emission (EVAP) system, canister purge valve
Idle speed actuator
Intake oil control valve
Ignition coil cylinder 1+4
Ignition coil cylinder 2+3
Injectors
Utility
Controls
Resetting adaptive values
Edit VIN
Front Oxygen Short-trip Test
Idle RPM Control Test(ISC Type Only)