Car, KIA, Korea, OPIRUS (GH), 2004, L 2.7 DOHC, L 2.7 DOHC - EMS ECU (ENGINE)
L 2.7 DOHC - EMS ECU (ENGINE) - 0
Identification
:
DTC
Controls
Clear DTC
Data stream
Battery voltage: 25.91 V
Ignition switch: On
Engine coolant temperature sensor: 4.96 V
Engine coolant temperature sensor: 143.2 °C
Intake air temperature sensor: 4.96 V
Intake air temperature sensor: 143.2 °C
Throttle position sensor: 4.961 V
Throttle position sensor: 119.5 °
Adapted throttle position sensor: 119.601 °
Mass air flow sensor: 4.96 V
Mass air flow sensor: 16382.4 kg/h
Vehicle speed: 255 km/h
Engine speed: 65535 rpm
Idle RPM check: 65535 rpm
CMP FALL EDGE: 255 Tooth
CMP RISE EDGE: 255 Tooth
Inhibitor switch: Drive
A/C switch: On
A/C compressor: On
A/C relay: On
A/C pressure switch: On
O2 sensor 1, bank 1: 319024.380 V
O2 sensor 1, bank 2: 319024.380 V
O2 sensor 2, bank 1: 319024.380 V
O2 sensor 2, bank 2: 319024.380 V
Ignition angle cylinder 1: -23.3 °
Ignition angle cylinder 2: -23.3 °
Ignition angle cylinder 3: -23.3 °
Ignition angle cylinder 4: -23.3 °
Ignition angle cylinder 5: -23.3 °
Ignition angle cylinder 6: -23.3 °
Injection time cylinder 1: 262.1 ms
Injection time cylinder 2: 262.1 ms
Injection time cylinder 3: 262.1 ms
Injection time cylinder 4: 262.1 ms
Injection time cylinder 5: 262.1 ms
Injection time cylinder 6: 262.1 ms
Injection time bank 1: 262.1 ms
Injection time bank 2: 262.1 ms
Fuel system status (bank 1): Closed Loop
Fuel system status (bank 2): Closed Loop
Short term fuel trim bank 1: 49.2 %
Short term fuel trim bank 2: 49.2 %
Air/Fuel ratio average bank 1: 49.2 %
Air/Fuel ratio average bank 2: 49.2 %
Long term fuel trim (idle) bank 1: 131.1 ms
Long term fuel trim (idle) bank 2: 131.1 ms
Long term fuel trim (part load) bank 1: 50.2 %
Long term fuel trim (part load) bank 2: 50.2 %
O2 sensor 1, bank 1 heater: 99.2 %
O2 sensor 1, bank 2 heater: 99.2 %
O2 sensor 2, bank 1 heater: 99.2 %
O2 sensor 2, bank 2 heater: 99.2 %
Idle speed actuator: 100.2 %
Idle speed correction: -0.0 %
Idle speed control adaption-M/T: -0.0 %
Idle speed control adaption-A/T: -0.0 %
Idle speed actuator adaptation (A/C): -0.0 %
Cooling fan low speed relay: On
Cooling fan high speed relay: On
Fuel cut-off: On
Engine operating status - full load: On
Cranking signal: On
Throttle closed position: On
Part load status: On
Ignition dwell time: 262.1 ms
Actuators test
Controls
Check engine telltale
A/C compressor relay
Cooling fan high speed relay
Cooling fan low speed relay
Main relay
Idle speed actuator
Ignition coil cylinder 1+4
Ignition coil cylinder 2+5
Ignition coil cylinder 3+6
Injectors
Utility
Controls
Resetting adaptive values
Auto detected configuration reset