Bil, HYUNDAI, General, G70 (IK), 2022, G 3.3 T-GDI, 4WD (4WD)

Software version bootloader:

ECU serial number ::

Vehicle manufacturer ECU hardware number:

Supplier ECU hardware number:

System ECU software number:

P183400: Actuator thermal overstress shutdown

Clear DTC

Motor Hastighed: -- Omdr.

Batteri spænding: -- V

Computed command torque: -- N·m

Computing clutch duty: -- %

PCB temperature: -- °C

Computed clutch stress: -- %

AWD warning lamp - ECU failure: --

AWD warning lamp - motor failure: --

AWD warning lamp - clutch failure: --

Køretøjs hastighed : -- km/h

Acceleration pedal: -- %

Brake active information: --

Gear position (current): --

Motor current: -- A

Ratvinkelføler: -- °

Actual clutch torque: -- N·m

Actual clutch pressure: -- bar

Computed motor stress: -- %

Diagnostic flag of ASW (vehicle observer): --

Diagnostic flag of ASW (cluth controller): --

Temporal diagnostic flag of BSW, HW 1: --

Temporal diagnostic flag of BSW, HW 2: --

Diagnostic flag of BSW, HW 1: --

Diagnostic flag of BSW, HW 2: --

Ignition status: --

Output shaft speed: -- Omdr.

Front axle: --

Steering angle offset: -- °

Drejningshastighed: -- °/sec

ESP control mode: --

ESP limitation mode: --

Hetero tire ratio: -- %

Hetero tire level: --

Delta speed between front and rear axle: -- Omdr.

Computed clutch work: -- kWh

Computed motor work: -- kWh

Raw value of sensor output: --

Lamp control

Clutch learning reset

Air Bleeding Mode