Car \ HYUNDAI \ General \ EON (HA) \ 2015 \ B 0.8 MPI \ B 0.8 MPI - Engine Control (ENGINE) B 0.8 MPI - Engine Control (ENGINE)

Car, HYUNDAI, General, EON (HA), 2015, B 0.8 MPI, B 0.8 MPI - Engine Control (ENGINE)

B 0.8 MPI - Engine Control (ENGINE) - 0

Identification

Calibration ID:

Calibration verification number (CVN): FF FF FF FF

Repairshop or tester serial number:

Calibration programm date: FF FF FF FF

Vehicle identification number:

Supplier ECU hardware number: FF FF FF FF FF

Supplier ECU software number:

Repair shop code or tester serial number:

Programming date: FF FF FF FF

DTC

Controls

Clear DTC

Data stream

Electrical load input - Head Lamp(Option): Off

Electrical load input - Defrost(Option): On

Driving status: A/T

Power steering switch: Off

Idle rpm control: Off

Ignition angle cylinder 1: 63.5 °

Ignition angle cylinder 2: 63.5 °

Ignition angle cylinder 3: 63.5 °

Ignition angle cylinder 4: 63.5 °

Injection time bank 1: 500.0 ms

Coolant temperature at engine start: 215 °C

Air intake temperature at start: 215 °C

Barometric pressure sensor: 200.0 kPa

Immobilizer type: Not supported

Immobilizer auto detection status: -

Immobilizer status: -

Idle CO adjusting value (Leaded Only): 1.000

Idle CO adaptation value (Leaded Only): 1.000

Actuators test

Controls

Check engine telltale

Fuel pump relay

A/C compressor relay

Fuel pump control

Immobilizer telltale

Cooling fan high speed

Cooling fan low speed

Canister Purge Valve (60%)

O2 Heater Front (30%)

O2 Heater Rear (30%)

Generator Control (Option) (80%)

Tachometer(Option) (2000rpm)

Idle Speed Actuator (30%)

Injectors

Utility

Controls

Resetting adaptive values

Edit VIN

Idle CO adjustment

Auto detected configuration reset