Car, HYUNDAI, General, ATOS (MXI)-PDF, 2008, G 1.1 SOHC, G 1.1 SOHC - Leaded All (ENGINE)

G 1.1 SOHC - Leaded All (ENGINE) - 0

Identification

HMC ID: FCE2N65

Part number:

Software version number:

Calibration ID: B261637054

Calibration ID 2: 9030930183

ROM ID: QF6NS05E

Version: M90AE28I

Engine: EURO-3

Code version: ALPHA1.6D

Program version: REP.SHOP.CD

Index number: 1709031751

Serial number: M79

Manufacturer serial number: qf6ns05e

DTC

Controls

Clear DTC

Data stream

A/C switch: On

Torque control request: On

Transmission range switch: Drive

A/C pressure switch: On

Check engine telltale: On

A/C compressor relay: On

Fan: On

Fuel pump: On

Throttle closed position: On

Power supply relay: On

Throttle wide open position: On

Fuel cut-off: On

Cranking signal: On

Fuel system status: On

Cranking signal: Running

MAP sensor: 319.81 V

MAP sensor: 2562.4 mbar

Engine load: 1535.5 %

Throttle position sensor: 4.98 V

Throttle position sensor: 100.0 %

Adapted throttle position sensor: 98.3 %

Battery voltage: 17.37 V

Battery charging: 100.0 %

Engine coolant temperature sensor: 143.2 °C

Intake air temperature sensor: 143.2 °C

Evaporative emission (EVAP) system, canister purge valve: 98.3 %

Injection time cylinder 1: 208.9 ms

Injection time cylinder 2: 208.9 ms

Injection time cylinder 3: 208.9 ms

Injection time cylinder 4: 208.9 ms

Target idle speed: 2550 rpm

Idle speed actuator: 100.0 %

Engine speed: 16383.8 rpm

Ignition angle cylinder 1: 191.2 °

Ignition angle cylinder 2: 191.2 °

Ignition angle cylinder 3: 191.2 °

Ignition angle cylinder 4: 191.2 °

Vehicle speed: 318.8 km/h

Knock adaption cylinder 1: -191.2 °

Knock adaption cylinder 2: -191.2 °

Knock adaption cylinder 3: -191.2 °

Knock adaption cylinder 4: -191.2 °

Exhaust gas temperature: 1225 °C

Actuators test

Controls

Check engine telltale

Fuel pump relay

A/C compressor relay

Fan

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

Ignition coil cylinder 1+4

Ignition coil cylinder 2+3

Injectors

Utility

Controls

Idle CO adjustment