Car, CITROEN, C4, NFU - Bosch ME7.4.5 CAN
NFU - Bosch ME7.4.5 CAN - 0
Identification
PSA reference: 96 54 59 60 80
ECU manufacturer: Magneti Marelli
Additional number: 96 54 59 60 80
Software version: 13 27
Software reference: 65 95 85
VIN no: VF7LCNFUC74896852
Engine type: NFU
Model: Unknown
DTC
P0502: Unknown DTC
Controls
Clear DTC
Data stream
Engine speed: 0.0 rpm
Battery voltage: 0.00 V
Injection time bank 1: 129.7 ms
Deceleration fuel cut-off: No
Throttle position sensor:
Throttle position sensor: -1 °
Throttle position sensor: 2.503 V
Engine coolant temperature sensor: 54.6 °C
Intake air temperature sensor: 143.0 °C
MAP sensor: 2550 mbar
Evaporative emission (EVAP) system, canister purge valve: Inactive
Ignition angle: 0.0 °
Coil 1,4 dwell time: 3.9 ms
Coil 2,3 dwell time: 3.9 ms
O2 sensor 1, bank 1: Inactive
O2 sensor 2, bank 1: Inactive
O2 sensor 1, bank 1: 0.46 V
O2 sensor 2, bank 1: 0.46 V
O2 sensor 1, bank 1 loop control: Open Loop
O2 sensor 2, bank 1 loop control: Open Loop
Canister electrovalve duty cycle: 0.0 %
A/C authorisation: No
A/C request: No
Clutch switch: Closed
Engine torque: 99.8 N·m
Engine load: Idle
Power supply: Inactive
Vehicle speed sensor: 0.0 km/h
Vehicle transmission type: M/T
Gear transmission ratio: N
Cooling fan relay: Inactive
Cooling fan triggering: 0.0 %
Cooling fan speed: 0.0 %
Refrigerant pressure: 1.4 bar
Immobilizer
Locking of the ECU: Locked
Immobilizer status: Programmed 1 times
Problem detected when transmitting the unlock code: No problem
Actuators test
Controls
Electronic throttle control (ETC)
Ignition coil cylinder 1+4
Ignition coil cylinder 2+3
Injector 1
Injector 2
Injector 3
Injector 4
Power supply relay
Cooling fan high speed
Cooling fan low speed
Evaporative emission (EVAP) system, canister purge valve
Utility
Controls
ECU learn reset