Car, CITROEN, BERLINGO (K9), 9HE (DV6DTED) - EDC17C10 BR2
9HE (DV6DTED) - EDC17C10 BR2 - 0
Identification
PSA reference: 96 66 07 72 80
ECU manufacturer: Bosch
Additional number: 96 66 72 95 80
Software version: B4 03
Software reference: 78 97 00
DTC
P151A: Starting monitoring. Immobilizer unlocking time too long
Controls
Clear DTC
Data stream
Camshaft and crankshaft synchronization: No
Status of last learning of EGR valve: Done
Last turbo initialisation: Done
Initialised initial position of EGR valve lower limit: 19 %
Last initialised position of EGR valve lower limit: 21 %
Initialised initial position of the turbo upper limit: 49 %
Initialised initial position of the turbo lower limit: 13 %
Last initialised position of turbo upper limit: 81 %
Last initialised position of turbo lower limit: 13 %
Engine speed: 21.2 rpm
Fuel regulating valve duty cycle: 14 %
Target fuel pressure: 170 bar
Fuel pressure measured: 22 bar
Calculated injection time: 0.7 mg/impulse
Injector 1 correction value: -49.0 mg/impulse
Injector 2 correction value: -1.2 mg/impulse
Injector 3 correction value: -3.0 mm³/stk
Injector 4 correction value: 5.7 mm³/stk
Fuel temperature sensor: 202 °C
Injector opening correction strategies activation status: Active
Injection time cylinder 1: 0.3 ms
Injection time cylinder 2: 1.8 ms
Injection time cylinder 3: 0.0 ms
Injection time cylinder 4: 1.8 ms
High pressure fuel pump: 352.9 mA
Fuel rail pressure reference value: Speed limiter active
Mass air flow sensor: 49 °C
Intake air temperature sensor: 53 °C
Turbo pressure: 1000 mbar
Measured turbo pressure: 997 mbar
Barometric pressure sensor: 981 mbar
Turbo position reference value: 0 %
Turbo position repeat: 41 %
EGR valve position: 0 %
EGR valve position repeat: 0 %
EGR valve open cycle ratio: -5.3 %
EGR exchanger bypass position reference value: 0 %
Outside air temperature: 25.0 °C
Turbo pressure duty cycle: 0 %
Target mass air flow: 367 mg/impulse
Mass air flow sensor: 0 mg/impulse
Vehicle speed sensor: 0 km/h
Cruise control system status: Inactive
Clutch pedal: Released
Speed limiter: Inactive
Main brake information: Released
Brake pedal redundant: Released
Accelerator pedal point of resistance sensor: Cleared
Accelerator pedal position sensor 1: 400 mV
Accelerator pedal position sensor 2: 200 mV
Accelerator pedal position sensor: 0 %
Gear transmission ratio: Neutral
Gearbox type: Manual
Cruise control speed setting: 0 km/h
Speed limiter speed setting: 0 km/h
Generator charge information: 500 ms
Battery voltage: 12.80 V
Temperature controlled generator: 20 °C
Power relay: Active
Additional heating: Inactive
Clutch pedal: 0 %
Starting inhibiting control (information filaire): Authorised
Starting inhibiting control (multiplexed information): Prohibited
Engine coolant temperature sensor: 118 °C
Cooling fan reference speed: 103 %
Cooling fan speed: 13 %
A/C circuit pressure: 8.0 bar
Oil pressure: Insufficient
Oil level: 41 mV
Engine status:
Additional information
Cylinder 1 injector code: F7 7F 9B D0
Cylinder 2 injector code: 01 F0 E0 28
Cylinder 3 injector code: 0E 01 C2 18
Cylinder 4 injector code: 0E 23 00 48
Immobilizer
Locking of the ECU: Locked
Immobilizer status: Matched ECU
Problem detected when transmitting the unlock code: No problem
Actuators test
Controls
Cooling fan high speed
Cooling fan low speed
Fuel flow regulator
EGR valve
Power supply relay
Pre-post heating relay control
Additional heating
Additive pump
Turbocharger actuator
EGR exchanger bypass
Checking pressurisation of air entering the engine
Air flow circulation
EGR circuit checking
Fuel rail pressure
Engine compressions test
Manifold inlet pressure sensor checking
Utility
Controls
Cylinder head replacement
EGR exchanger replacement
EGR valve change
High Pressure pump replacement
Injectors replacement
Resetting the health condition of the energy accumulator