Car, CITROEN, DISPATCH, JUMPY 3, 9HH - EDC17C10 BR2

9HH - EDC17C10 BR2 - 0

Identification

PSA reference: 01 01 01 01 01

ECU manufacturer: Not available

Additional number: 01 01 01 01 01

Software version: 08 51

Software reference: 79 17 53

DTC

P1505: Intersystems CAN. Airbag ECU has requested stopping of engine (following the detection of an impact)

Controls

Clear DTC

Data stream

Camshaft and crankshaft synchronization: Yes

Status of last learning of EGR valve: Done

Last turbo initialisation: Not carried out

Last initialised position of EGR valve lower limit: 88 %

Engine speed: 0.0 rpm

Fuel flow regulator: 8 %

Target fuel pressure: 283 bar

Fuel pressure measured: 5 bar

Calculated injected flow: 0.0 mg/impulse

Injector 1 correction value: 0.0 mg/impulse

Injector 2 correction value: 0.0 mg/impulse

Injector 3 correction value: 0.0 mm³/stk

Injector 4 correction value: 0.0 mm³/stk

Fuel temperature sensor: 45 °C

Injector opening correction strategies activation status: Inactive

Injection time cylinder 1: 0.0 ms

Injection time cylinder 2: 0.0 ms

Injection time cylinder 3: 0.0 ms

Injection time cylinder 4: 0.0 ms

High pressure fuel pump: 1892.2 mA

Fuel rail pressure reference value: No limitation

Mass air flow sensor: 18 °C

Intake air temperature sensor: -37 °C

Turbocharging pressure reference value: 15 mbar

Measured turbo pressure: 31 mbar

Barometric pressure sensor: 255 mbar

Turbo position repeat: 11 %

Vehicle speed sensor: 175 km/h

Cruise control system status: Active

Clutch pedal: Released

Speed limiter: Active

Main brake information: Pressed

Brake pedal redundant: Pressed

Accelerator pedal point of resistance sensor: Cleared

Accelerator pedal position sensor 1: 128 mV

Accelerator pedal position sensor 2: 15 mV

Accelerator pedal position sensor: 50 %

Gear transmission ratio: Parking

Gearbox type: Automatic

Cruise control speed setting: 186 km/h

Speed limiter speed setting: 175 km/h

Generator: 2550 ms

Battery voltage: 1.50 V

Engine coolant temperature sensor: 120 °C

Cooling fan reference speed: 170 %

Cooling fan speed: 12 %

A/C circuit pressure: 15.5 bar

Oil pressure: Insufficient

Oil level: 135 mV

Engine status: Autonomous restarting

Cylinder 1 injector code: 01 02 03 04

Cylinder 2 injector code: 11 99 00 00

Cylinder 3 injector code: 07 08 09 01

Cylinder 4 injector code: 44 00 00 00

Immobilizer

Locking of the ECU: Unlocked

Immobilizer status: After-sales status

Problem detected when transmitting the unlock code: No problem

Actuators test

Controls

Turbocharger actuator

EGR exchanger bypass

Checking pressurisation of air entering the engine

Checking engine setting

Air flow circulation

EGR circuit checking

Checking the functioning of the air circuit assembly

Fuel rail pressure

Engine compressions test

Manifold inlet pressure sensor checking

Cooling fan high speed

Cooling fan low speed

Fuel flow regulator

EGR valve

Air mixer

O2 sensor 1, bank 1 heater

Power supply relay

Pre-post heating relay control

Additional heating

Additive pump

Utility

Controls

Injectors replacement

EGR valve change

EGR exchanger replacement

Turbocharger replacement

Exhaust manifold replacement

Cylinder head replacement

High Pressure pump replacement

Resetting the health condition of the energy accumulator